How To Article | HTA-20230623-AVW-01 iProtect Access / Security | How To Articles | How to update iProtect™ to 10.3

How to update the iProtect™ Application.

Introduction

This how-to guide provides you with instructions on how to update your iProtect 10.02 system to the latest 10.03 version, allowing you to take advantage of the latest improvements and features.

Update workflow

...

Download files

Download the latest files on our download section of the knowledgebase:

...

• Firmware intrusion detection (Unii 2.4.0 / XL 3.11 / ML is EOL)

• Rootfs Pluto's (5.68a)

• Firmware polyx (UBIFS)

• Diva/Sense (2.6.13)

• iProtect version 10.21.x37

Network requirements

Since iProtect version 10.03 the network communication between the server and the Pluto devices has changed. Previously, we were only using a TCP77 connection, but now we are able to communicate over secure WebSockets.

https://en.wikipedia.org/wiki/WebSocket

For this reason, some additional ports need to be opened. See the page below for more details.

Network sockets - IPROTECT Access

Firewall settings

The firewall on the iProtect server is set by default to allow network traffic with TKH access control controllers. When connecting a third-party system to iProtect, the necessary network port settings must be added to the firewall.

These firewall rules can be adjusted via the system's Cockpit Panel, which is accessible at the following URL: https://{ipaddress/hostname}/cockpitpanel

Getting the necessary files

...

Cockpitpanel is reachable by the url https://{ipadress/hostname}/cockpitpanel

Install the new serverbox at the maintenance page.

...