...
How To Article | HTA-20230623-AVW-01 iProtect Access / Security | How To Articles | How to update iProtect™ to 10.3  |
| Table of Contents |
|---|
How to update the iProtect™ Application.
Introduction
This how-to guide provides you with instructions on how to update your iProtect system to the latest 10.03 version, allowing you to take advantage of the latest improvements and features.
...
Firmware intrusion detection (Unii UNii 2.4.0 / Alpha XL 3.11 / Alpha XL ML is EOL)
Rootfs Pluto's (5.68a)
Firmware polyx Polyx (UBIFS)
Diva/VDG-Sense (2.6.13)
iProtect version 10.1.37
...
Since iProtect version 10.03 the network communication between the server and the Pluto devices has changed. Previously, we were only using a TCP77 connection, but now we are able to communicate over secure WebSockets.
https://en.wikipedia.org/wiki/WebSocket
For this reason, some additional ports need to be opened. See the page below for more details.
our own communication protocol. When updating to iProtect 10.3, secure WebSockets are used.
| Note |
|---|
It is necessary to set up certain network ports to switch to using Websockets. Please read the page carefully! Network sockets - IPROTECT Access |
Firewall settings
The firewall on the iProtect server is set by default to allow network traffic with TKH access control controllers. When connecting a third-party system to iProtect, the necessary network port settings must be added to the firewall.
...
First, it is important to bring the server fully up-to-date, you can do this by going to the “Software updates” tab in CockpitPanel and then running a scan to see if any updates are available.
...
Activate the line’s now, the Door controllers ‘door controllers’ will get the new software and start with the installation automatically. The doors will be non-functional for 5-10 minutes. Open doors beforehand if they are critical.
...