...
How To Article | HTA-20230623-AVW-01 iProtect Access / Security | How To Articles | How to update iProtect™ to 10.3  |
| Table of Contents |
|---|
How to update the iProtect™ Application.
Introduction
This how-to guide provides you with instructions on how to update your iProtect system to the latest 10.03 version, allowing you to take advantage of the latest improvements and features.
...
Compatibility and discontinued hardware/software is noted in the release notes:
iProtect IPROTECT - Release notes 10.3
Minimal requirements / tested versions:
Firmware intrusion detection (UNii 2.4.0 / Alpha XL 3.11 / Alpha XL ML is EOL)
Rootfs Pluto's (5.68a)
Firmware Polyx (UBIFS)
Diva/VDG-Sense (2.6.13)
iProtect version 10.1.37
IPROTECT 10.3 - INTEGRATIONS - SOFTWARE & FIRMWARE
Network requirements
Since iProtect version 10.03 the network communication between the server and the Pluto devices has changed. Previously, we were only using our own communication protocol. When updating to iProtect 10.3, secure WebSockets are used.
| Note |
|---|
It is necessary to set up certain network ports to switch to using Websockets. Please read the page carefully! IPROTECT Access - Network sockets - IPROTECT Access |
Firewall settings
The firewall on the iProtect server is set by default to allow network traffic with TKH access control controllers. When connecting a third-party system to iProtect, the necessary network port settings must be added to the firewall.
...
...