...
How To Article | HTA-20230204-LG-01 iProtect Access / Security | How To Articles |  |
|
| Table of Contents |
|---|
Description:
The purpose of this guide is to explain the provisioner with some examples.
...
Beschreibung:
Der Zweck dieses Leitfadens ist es, den Provisioner anhand einiger Beispiele zu erklären.
Das Wesentliche:
Sufficient rights to create a provisioner.
Firmware or config files
Configuration:
In iProtect 8.04 there are provisioner for lines and nodes. iProtect 9.10 and higher is necessary for provisioning of reader configurations. iProtect 10.1 and higher is needed for reader firmware upgrades (Pluto - Orion - RS485 only).
Example 1 - New reader manager
Step 1 - Save the file to iProtect
Go to the media element to upload the new reader manager:
...
Set the Type to “PROVISIONER” and upload the new reader manager with the “Upload” button. use as name the full name of the reader manager file. Press save and the first step is done.
Step 2 - Make a provisioner element.
Go to “Provisioner element”:
...
Set the type to “Pluto - Reader manager” and select the file you just have uploaded at “Provisioner file”. And make it the same name. Also set the provisioner element active and press the “Save” button.
Step 3 - Make a provisioner group.
You can’t change system generated provisioner groups, so the best is to make a new one now
...
Press “Save” to save the new provisioner group.
Step 4 - Select the provisioner at the Line.
Go to “Line”:
Installation > Hardware > Line
...
0 means that it is busy with the one element, if you see 1 or higher, then the numbers is the que length..
Example 2 - New reader firmware
Step 1 - Save the file to iProtect
Go to the media element to upload the new reader manager:
...
Set the Type to “PROVISIONER” and upload the new reader manager with the “Upload” button. use as name the full name of the reader manager file. Press save and the first step is done.
Step 2 - Make a provisioner element.
Go to “Provisioner element”:
...
Set the type to “Reader - Sirius iX firmware” and select the file you just have uploaded at “Provisioner file”. And make it the same name. Also set the provisioner element active and press the “Save” button.
Step 3 - Make a provisioner group.
You can’t change system generated provisioner groups, so the best is to make a new one now
...
Press “Save” to save the new provisioner group.
Step 4 - Select the provisioner at the Node.
Go to “Line”:
Installation > Hardware > Line
...