...
Installation Manual | TM-20231130-RD-01 iProtect Access / Security | Functionalities | Nedap target reader UHF  |
This manual represents the knowledge at the above-mentioned time. TKH security works non-stop to improve her products. For the most recent technical information please contact your consultant or dealer.
Table of contents
| Table of Contents |
|---|
1. Introduction
...
Version | License |
|---|---|
Version 10.3.15 | iProtect basic license |
Sufficient reader licenselicenses |
2.1 Supported cards
UHF DNA cards for specific project
...
The discover function for OSDP devices checks for the following settings:
Baudrate:
9600, 19K2, 115K2
Parity: None
Data bits: 8
Stop bit: 1
Device address: 0, 1, 2, 3, 4, 5, 6, 7, 8, 13, 14, 24
If other settings are necessary, set these settings manually.
| Info |
|---|
...
Nedap target |
...
defaults: 9600N81 |
...
, OSDP address 0 |
...
Setup Target reader |
...
: Nedap UHF tool |
...
5.3 OSDP reader settings
For OSDP readers there are some specific settings.
...
| Note |
|---|
Once a key is set into the reader it cannot be cleared or rewritten by the system (not allowed in the OSDP protocol, security risk). If the key must be cleared (Reset) follow the procedure what is delivered by the reader manufacturer. |
7. General notes
by By normal operation:
The red led
...
ON,
...
Idle situation
The red led is
...
Blinking, Access denied
The green led is
...
ON, Access granted
The led is purple when the connection is lost with the stacked Orion
8. iProtect settings
8.1 Card data presentation
Nedap target, with DNA tags:
Card data presentation | ||
|---|---|---|
Format | Decimal | |
Calculated length | 9 |
8.2 Card data interpretation
Card data interpretation | ||
|---|---|---|
Format | ||
Reader communication protocol | HEX | |
Card type | None | |
Data length | 28 | |
System code | ||
Start | 1 | |
Code | “empty“ | |
facility | ||
Start | 1 | |
Code | “empty“ | |
Card number | Start | 22 |
Length | 7 | |
Modulo | “empty“ | |
Offset | “empty“ |