Devices – Advanced settings

Introduction

The Advanced tab is used to configure special settings for the selected device. These options are enables by the preceding checkbox and can be different depending on the chosen device type and license.

 

Audio

Enables audio recording for selected device

Dewarping

Enables dewarping for selected device. This option is available in the Sense Pro license. (Read more)

Prefer RTSP over TCP

Prefer connection over TCP. If TCP is not available, the default UDP will be used as fallback. Cannot be used in combination with multicast.

On demand streaming

Enables on demand streaming The device will only stream (and record) when requested by client.

RTP timestamps

If enabled the set time of the camera is used as timestamp for video recording. When using this setting it is important that the time of the camera is synchronized with a time server.

Enable multi streaming

Enables multi streaming for selected device. (Read more)

Multicast 

Enables multicast for selected device. (Read more)

Record

Choose which stream to record

VCA

Choose which stream to do VCA on (all VCA; Motion, SceneR, SiquraVCA, CarR, ObjectC)

VideoSmoothing

Enabling VideoSmoothing will show live video more smoothly in operator mode. Especially when using high resolution cameras in combination with VCA like motion or ObjectR Advanced video could start lagging. With this setting the video can be smoothened. The buffertime is 300ms by default and can be increased if required.

Multi Streaming

For selected TKH Security Solution or Hikvision driver cameras, triple streaming is supported. This means VDG Sense can use a third stream for either recording, displaying or VCA.

Stream Settings

 

For TKH Security Solution or Hikvision driver cameras it is possible to change the video settings for all supported streams.

  • Resolution

    • All supported resolutions for that specific camera will be available in the selection list

  • Bandwidth:

    • Choose the bandwidth to be used by camera

  • Framerate

    • All supported framerates for that specific camera will be available in the selection list

NOTE

Framerate setting for these drivers is removed from Profiles->General tab. To change resolution, Bandwidth or framerate a viewer or server macro can be used.

  • Video->Device->Bandwidth->Stream1/2/3

  • Video->Device->Framerate->Stream1/2/3

  • Video->Device->Resolution->Stream1/2/3