Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Installation Manual | TM-20230629-AVW-01

iProtect Access / Security | Functionalities |Voxio-T-1570-Z reader

Image Modified

This manual represents the knowledge at the above-mentioned time. TKH security works non-stop to improve her products. For the most recent technical information please contact your consultant or dealer.

...

Below is an overview of support for both the hardware and the software, including the necessary license:

Version

License

Version 10.3.15

iProtect basic license

Sufficient reader license

2.1 Supported cards

  • TKH coded DESFire cards

  • Legic prime

...

4.1 Connecting the reader

PHG connector

Signal

CAT5 cable > Orion PRT 1 or 2

Pin 1

VCC 8-30V DC

Pin 2

GND

Pin 3

B

White/Orange & White/Green

Pin 4

A

Orange&Green

...

Info

Max. cable distance between Orion and the PHG reader = 30 Mtr. This is based on CAT5E - 24AWG

Info

This cable distance is based without installing an external power supply.

...

It’s possible to setup the buzzer time when a card is recognized, this can be done at the door behavior tab of the reader.

Buzzer time | card recognized

Setting

Behavior

Empty

No buzzer when card is recognized

1 - 15

buzzer time (1/10 sec)

Info

Most used setting for buzzer time = 2

5.4 Keypad buttons

Keypad

Description

0-9

Numeric numbers

C

On keypad is used as restore key to re-enter the PIN on the pending access request.

E

On keypad is used for reset pincode (do not use as pincode only key).

By reset pincode when using the pincode only function an reader error event occurs, with Error description: “Error: Wrong numbers of characters received”

...

The reader authentication method can be set at the general tab on the reader detail page.

6. Secure channel

OSDP v2 with Secure Channel has AES-128 encryption to ensure that communication between the targeted devices is strict and secure.

...

Note

Once a key is set into the reader it cannot be cleared or rewritten by the system if the current key is not known. (not allowed in the OSDP protocol, security risk). If the key must be cleared (Reset) follow the procedure what is delivered by the reader manufacturer.